• Black, 1ea/190 GPH, 10Ft Cord
1 1

EUGENE G DANNER MANUFACTURING

Danner Pondmaster Fountain-Mag Magnetic Drive Water Pump

SKU: PT0172502519

Black, 1ea/190 GPH, 10Ft Cord

$45.20 USD
$35.76 USD $45.20 USD
Sale Sold out

Ideal for statuary, ponds and aquariums. Energy-efficient with adjustable flow control. Can be used in a horizontal or vertical position.

Dimension

  • Product Gross Weight: 1.9000 lb
  • Product Net Weight: 1.9000 lb
  • Product Height: 4.40 in
  • Product Length: 6.50 in
  • Product Width: 4.50 in

Instruction

  • Use Instructions: Pump must be used submersed, down to a maximum depth of 24”. When water depth is low, always place the screen side down. The pump is intended to pump water only. It cannot be used to pump oil, solvents, or gasoline. Do not run pump dry.

Safety

  • Caution: Always use a properly grounded outlet. Do not immerse plug in water. Do not reach into water to remove plug. turn off circuit first. A drip loop should be provided. the drip loop is a loop in the cord below the level of the receptacle or plug that prevents water from traveling along the cord. The national electric code requires that a ground fault circuit interrupter (GFCI) be installed in the branch circuit supplying fountain or pond equipment. Your dealer can supply GFCI units. Never remove ground pin from plug. warning: for your protection always unplug the unit from its power source before installing or servicing. Should the unit appear to be not working do not reach remove or disassemble unit before you disconnect power. The pump is intended to pump water only. It cannot be used to pump oils, solvents or gasoline.
  • Safety Listing: UL
  • Safety Warnings: a. To avoid possible electric shock, special care should be taken since water is employed in the use of aquarium equipment. For each of the following situations, do not attempt repairs by yourself; return the appliance to an authorized service facility for service or discard the appliance:1) If the appliance shows any sign of abnormal water leakage, immediately unplug it from the power source. (Immersible equipment only)2) Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not intended to be wet.3) Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or has been dropped or damaged in any manner4) To avoid the possibility of the appliance plug or receptacle getting wet, position aquarium stand and tank to one side of a wall-mounted receptacle to prevent water from dripping onto the receptacle or plug. A “drip loop,” shown in the figure below, should be arranged by the user for each cord connecting an aquarium appliance to a receptacle. The “drip loop” is that part of the cord below the level of the receptacle, or the connector if an extension cord is used, to prevent water traveling along the cord and coming in contact with the receptacle. If the plug or receptacle does get wet, DON’T unplug the cord. Disconnectthe fuse or circuit breaker that supplies power to the appliance. Then, unplug and examine for presence of water in the receptacle.c) Close supervision is necessary when any appliance is used by or near childrend) To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors, lamp bulbs, and the likee) Always unplug an appliance from an outlet when not in use, before putting on or taking off parts, and before cleaning. Never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.f) Do not use an appliance for other than intended use. The use of attachments not recommended or sold by the appliance manufacturer may cause an unsafe condition.g) Do not install or store the appliance where it will be exposed to the weather or to temperatures below freezingh) Make sure an appliance mounted on a tank is securely installed before operating iti) Read and observe all the important notices on the appliancej) If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.k) This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do not attempt to defeat this safety feature.

Specifications

  • Compatible With: Small to medium size fountains; small ponds
  • Cord Length: 120 Inches
  • Voltage: 120 Volts
  • Wattage: 19 Watts