Danner Pondmaster The Fountain & Statuary Water Pump
SKU: PT0172501717Black, 1ea/200 GPH, 6Ft Cord
Regular price
$32.57 USD
Regular price
$25.66 USD
Sale price
$32.57 USD
Unit price
per
Energy-Efficient Magnetic Drive. 6' Power Cord with Grounded Plug. For Inline or Submersible Use. Variable Flow Control. Debris-Reducing Pre-Filter. Fish Safe. 1/2 in, 5/8in and 3/4in Barb fitting. 1 Year Warranty
Dimension
Dimension
- Product Gross Weight: 1.3300 lb
- Product Net Weight: 1.3300 lb
- Product Height: 3.50 in
- Product Length: 6.25 in
- Product Width: 4.25 in
Instruction
Instruction
- Use Instructions: 1. Unplug pump. Remove the front cover. Remove Impeller Cover with O-Ring by turning counter clockwise & pulling away from Motor Housing. 2. Position Inline Impeller cover with arrow pointing UP, align the center hole with the Impeller End Cap and press into motor housing until completely seated. Turn clockwise until it stops (about 10 degrees).3. Ring clamp must be used to lock Inline Impeller Cover in place. Loosen Screw and Nut on Ring Clamp, align slots on Ring Clamp with Fins on Inline Impeller Cover.
Safety
Safety
- Caution: 1. This pump has been evaluated for use with water only2. Always disconnect from electrical outlet before handling the pump3. Don’t operate without water4. Do not lift the pump by the power cord5. Operate in clean water only6. Operate pump completely submerged for optimum cooling7. Not for use in swimming pools or swimming pondsThis pump is only to be used in an outlet with a ground fault circuit interrupter (GFCI) or residual current device (RCD) with a rated residual operating current not exceeding 30 mA. NOTE: Ensure that the electrical cord loops below the electrical outlet to form a “Drip Loop” This will prevent water from running down the cord into the electrical outlet.
- Safety Warnings: 1. Ensure that the electrical cord is looped below the electrical outlet to form a “Drip Loop”. This will prevent water from running down the cord into the electrical outlet.2. Risk of electric shock- This pump is supplied with grounding conductor and grounding-type attachment plug. To reduce the risk of electric shock, be certain that it is connected only to properly grounded grounding-type receptacle.3. Do not remove the grounding pin from the plug4. Do not connect to any voltage other than that shown on the pump5. Do not pump flammable liquids6. The National Electric Code requires that a Ground Fault Circuit interrupter (GFCI) be used in the branch circuit supplying fountain pumps and other pond equipment. See your electrical supplies dealer for this device.7. The pump is to be supplied through a Residual Current Device (RCD) with a rated residual operating current not exceeding 30mA8. To reduce the risk of electrical shock, use only on portable self - contained fountains9. Do not use with water above 95°F (35°C)
Specifications
Specifications
- Compatible With: Small ponds
- Cord Length: 180 Inches
- Number of Outlets: 1 Count
- Voltage: 120 Volts
- Wattage: 14 Watts