• White, 1ea
1 1

RADIO SYSTEMS CORPORATION

Drinkwell Original Pet Fountain 50oz

SKU: PT0117113704

White, 1ea

$0.50 USD
$0.00 USD $0.50 USD
Sale Sold out

Developed by a Veterinarian, the Drinkwell Original Pet Fountain provides 50 oz of fresh, filtered water to your pet. A patented free-falling stream of water entices your pet to drink more and continually aerates the water with healthful oxygen. A charcoal filter removes bad tastes and odors, giving your pet the best way to stay hydrated!

Dimension

  • Dishwasher Safe: Top Rack Only
  • Product Gross Weight: 2.6500 lb
  • Product Net Weight: 2.6500 lb
  • Product Height: 14.00 in
  • Product Length: 7.13 in
  • Product Width: 9.38 in
  • Capacity: 50 oz
  • Environment: Indoor

Instruction

  • Assembly Required?: No
  • Use Instructions: Do not run dry - for indoor use only. Fountain will come fully assembled and ready for use. 1. As with any electrical device, check the electrical power cord for any tears or damage before use.2. Make sure the In-Line Plug is connected. When connected properly the silver tip is not showing.3. Remove the Housing by pressing the side tabs and lifting up. Inspect the inside of the fountain to ensure Pump is securely attached. Snap Housing back into place.4. Remove the Housing Lid and set aside. 5. Insert the Charcoal Filter. The Charcoal Filter fits diagonally into the two triangular slots located inside the Housing. The Charcoal Filter fits narrow side down, with the black side facing the front of the fountain towards the spout. The Charcoal Filter will slide easily into place, but make sure it is pushed all the way down. Important: Rinse the Charcoal Filter thoroughly under cool water before placing in the fountain. This will remove any loose charcoal dust, which is harmless. A small amount of charcoal dust may be released for the life of the Charcoal Filter. This is normal and is not harmful to your pet.6. Fill the Bowl with water. Replace the Housing Lid. 7. Place fountain in desired location. Do not pick up a full fountain by the Housing. Only pick up the fountain by placing both hands underneath the base of the fountain and grip the sidewalls for a sturdy hold. Important: To protect your floor always use a protective mat such as a towel or water-resistant placement. This will help protect your floor from any splashing or spills caused by your pet.8. Before you plug in the fountain, make sure the electrical power cord and your hands are dry. Plug the fountain into a standard electrical wall outlet.9. Set your desired flow rate with the Flow Control Knob, which is located to the right of the receiving ramp inside the Bowl. When the Flow Control Knob is in the 10 o’clock position, flow is at its lowest. When the Flow Control Knob is in the 2 o’clock position, flow is at its highest. 10. Add water to the Bowl as needed. Do not let the water level fall below the Flow Control Knob or you may risk Pump failure. Replacement Pumps are sold separately by calling the Customer Care Center at 1-800-732-2677
  • Care and Cleaning Instructions: Important: Fountain must be cleaned to continue working normally.Charcoal Filter: The Charcoal Filter should be changed every two to four weeks.1. Replace the Charcoal Filter more frequently when using the fountain for multiple pets or pets that produce a lot of saliva.2. The Charcoal Filter is an added feature of the fountain. The use of a filter is not required for normal operation, but using a filter will keep the fountain water cleaner.3. The Charcoal Filter may be rinsed out when the fountain is cleaned. Never wash the filter with soapy water, as you will not be able to remove the soap residue.Pet Fountain: Clean the fountain once a week.1. Unplug the fountain and disconnect the In-Line Plug.2. Remove Housing Lid and remove the Charcoal Filter.3. Empty the water out of the fountain.4. Remove the Housing by pressing in the side tabs and lifting up.Important: The Flow Control Knob is attached to the Pump. Do not attempt to remove the Pump by pulling on the Flow Control Knob as this can damage or break the Pump.5. Remove the Pump from its cavity by placing your index finger behind Pump and gripping the bottom with your thumb.6. Lift the Pump straight up – this may require slight force until the suction cups release.7. Next, remove the Pump from the fountain by disconnecting the In-line Plug and disengaging the rubber gasket. Pull the In-Line Plug up through the hole located next to the Pump. Clean away any hair, debris or kibble that may have accumulated around the Flow Control Knob and the Faceplate of the Pump.8. Once the fountain is completely disassembled you will have 3 plastic parts.9. Clean the fountain plastic parts with warm water and soap. You can also put the fountain in the top rack of the dishwasher. Remove the Pump before placing thefountain in the dishwasher. DO NOT PLACE PUMP IN DISHWASHER! If possible, it is recommended that you turn down the heat of the water inside the dishwasher.The fountain may also be cleaned with a diluted vinegar solution (20% White Vinegar and 80% Water). Be sure to rinse thoroughly with fresh water.10. If you have trouble reaching certain spots or hard-to reach corners, try using a cotton swab or purchase the Drinkwell® Cleaning Kit, a 3-Piece Brush kit.Pump MaintenanceImportant: Cleaning the Pump is essential to the longevity of the fountain, as well as the cleanliness of the water. Clean the Pump every two weeks. Warranty may be voided if the Pump’s motor is not cleaned regularly.1. Remove Pump from the fountain.2. Once the pump is out of the fountain, with your thumb and forefinger, gently squeeze on either side of the Faceplate, and pull it off. It may be necessary to insert a fingernail into the seam of the Faceplate to pry it off.3. Next, you will want to remove the Intake Plate by placing your fingernail underneath the small lip located on the narrow side of the tear drop shaped Intake Plate Pull-Tab and pull it out.4. Once the Intake Plate is removed, you can also remove the Impeller (white, 3-bladed propeller) which is held in place magnetically. To remove the Impeller, use a fingernail to get underneath a blade and lift out.5. Once the Pump is disassembled you can clean the parts with warm water and soap. Use a cotton swab or the “motor brush” from the Drinkwell® Cleaning Kit to get into the Pump’s motor cavity and remove any build-up. For added disinfecting and hard water removal, clean the Pump’s motor with a diluted vinegar solution (20% White Vinegar and 80% Water). Be sure to rinse thoroughly with fresh water.6. Once the parts are clean you can reassemble the Pump for use.a) Replace the Impeller.b) Replace the Stator.c) Replace the Faceplate with the Flow Control Knob attached to it.

Safety

  • Safety Listing: UL-Listed
  • Safety Warnings: When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and/or injury to persons, including the following:1. To reduce the risk of injury, close supervision is necessary when an appliance is used by or near children.2. To protect against electric shock, do not place Power Cord or plug in water or other liquids.3. Only use attachments recommended or sold by the manufacturer. 4. Do not use outdoors. FOR INDOOR HOUSEHOLD USE ONLY. 5. Do not unplug by pulling on Power Cord. To unplug, grasp the plug, not the Power Cord.6. Do not operate any appliance if it has a damaged Power Cord or plug, or if it is malfunctioning or has been damaged. Call Customer Care Center immediately for further instructions. 7. For a portable appliance - To reduce the risk of electrical shock, do not place or store an appliance where it can fall or be pulled into a tub or sink.8. Always unplug any appliance when not in use, before putting on or taking off parts and before cleaning. Never pull on the electrical Power Cord to remove the plug from the wall outlet.9. Do not use an appliance for anything other than its intended use.10. If the plug of this device gets wet, turn off the electricity to that wall outlet. Do not attempt to unplug.11. Examine this appliance after installation. Do not plug in if there is water on the Power Cord or plug.12. Do not allow pets to chew on or swallow any parts. If you are concerned about the Power Cord, purchase a cord conduit (a hard plastic protector) at any hardware store to protect the Power Cord.13. The fountain parts are BPA-FREE. However, some animals have been known to be sensitive to plastic food and water containers. If your animal shows signs of an allergic reaction to the plastic, please discontinue use until you have consulted with your veterinarian.

Specifications

  • Filter Types: Charcoal
  • Voltage: 12 Volts
  • Wattage: 2 Watts